Jump to content

Leaderboard

    [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]]

Popular Content

Showing content with the highest reputation on 01/29/19 in all areas

  1. Andrew96_
    FINALLY bagged some cpu's when I asked my supplier about the GAL chips for the JPM Impact cpu card project! so after 4 years these are finally nearing completion! will be nice to finally get this and impact done at last!
    2 points
  2. Digby
    P1 sets the game type. They identify with a suffix. They are K is arcade d is data Y is % key fitted s is standard. Etc etc
    2 points
  3. Brigham
    The Brenco arrived this morning, and it's every bit as good as it looks in the pictures. It must have been in a private club or hotel; it couldn't look like this after arcade use! The reels are slow to set off, the clutches are slipping. I was expecting the usual steel and leather discs. Instead we have two nylon bars, one of which is spring-loaded against a boss on the reel spindle. Friction is minimal; the first reel has barely started to turn before the stop-arm drops. Are there any tips for this type of clutch, before I start taking things to bits?
    1 point
  4. Eastenders
    If coins dont except hold the coin in your hand put your hand up to your mouth holding the coin and breathe on it a few times and it should except !!
    1 point
  5. DAD
    Are you having a go at this mate? I have a WIP 90% done if it would help. I'd be more than happy to send it over. If not could you do me a hi-res scan of the flyer please, and I'll give it a go? Thanks
    1 point
  6. housi
    my heart beats faster
    1 point
  7. Louie Bee
    MPS2 has no triacs on the MPU - they are on the hex pack. Possible that one of the transistors has gone short circuit (Q1-Q16) top left. they are each protected by resistor (R1-R16) respectivley... the 2.2 ohm resistor is also fusible so goes open circuit for protection. Sometimes it's just the resistor that has gone open circuit and thr transistor is OK. Transistor is a TIPP116 - also found on maygay M1b, JPM system5 and possibley Impact (Maybe more) but is no longer made. Fusible resistor can be a pain to get but aparantely can't be replaced by a normal carbon film 2.2 ohm resistor as the transistor can burn through the board. I did get a load of suposed fusible resistors but found them to not fuse so I only use ones from scrap boards these days. I'd start by checking the resistance of R1 to R16. one or more will probabley be open circuit...
    1 point
×
×
  • Create New...