Leaderboard

This is a design fault recognised by project as all the PC 92 machines were burning out the same component when new. They explained it as being underrated and sent out a replacement guide

Set on 20p play with the jackpots at £3 cash/ £6 tokens thanks to the rom provider, and to wizard for the amazing emulator. there is 1 lamp i am not 100% on and that is for unlimited nudges as i have stuck over £500 in and it has never gave them. anyhow, it is ready for a few wins. Quids In.zip

Massive thanks to amot for the roms, evo1 for testing, and to wizard for the amazing emulator. there is 2 layouts 1. set on 10p with the jackpot at £5 2. is set on 20p with the jackpot at £8 both are jackpot ready. if you like to play on 2p with the jackpot at £3 config and put dips 4 5 and 7 on. High Roller.zip

Here we have Cluedo DX based on the classic I did. Multi stake, £70 Jackpot. Shortcuts are the same as the classic and are the notes. Thanks go to Player for the scans he did Tommy C for helping cab it up and testing Wizard for his amazing emulator. Please use MFME 19.8 or above Hope you enjoy it. Cluedo £70 DX Release.zip

I have tons of hi tec fixes lol. How do you think I keep 100 machines running 🤣🤣🤣

so it was NOT the same as the other one next to it then 🤣

@Dazza So it's 560 ohm not 56K, sorry about that. Also, the original resistor is rated at 0.4 watts, so best use a 1 watt replacement rather than 0.5 watt as that's too close for comfort.

Maybe they do, but there are lots of different shapes and sizes of buttons. If you'd given some dimensions in your original post that would have sped things up a bit!

maybe be a bit more patient , not everyone reads all posts all the time and posts are easily missed the forum has a members only Wanted section especially for your type of post

Hi Ronnie, Thank you for your reply (sorry for the delay in my response) . Before reading your reply my fluorescents were on but the credit display was not and neither were any other lights and sounds. I then stripped the machine and put back and now the fluorescents are off but I have '03' displayed on the credits which is somewhat encouraging (as I assume this is an error code). I see only two LEDs on the main circuit board now. I reseated the cables about 5 times but it made no difference (but I did not clean contacts - I will try that next; any cleaning tips?) See photos below. By the way, I found the Service Manual for it which I forgot I had (I will scan an upload for others as soon as I have time).

Yeah Mux 31 error. Sometimes they do run normally and flashes up on the alpha. The bulbs can glow very bright and melt the lamp mask and artwork

Nobody on here has spare buttons ?