Jump to content

Leaderboard

    [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] [[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]]

Popular Content

Showing content with the highest reputation on 08/20/20 in all areas

  1. midibob
    One little tip that I find works well is to resolder the pins first as the good solder mixes with the old contaminated stuff, then use the sucker. Normally comes out clean every time. Also plenty of flux, top and bottom.
    3 points
  2. Andrew96_
    too hot and the print lifts away, too low heat and you pull out the through holes! about 380 deg C works well on old solder
    2 points
  3. riche100
    hello and a very warm welcome to you
    1 point
×
×
  • Create New...