Leaderboard

Good bit of restorative work there. I would check under the heatsink too as I've seen the green plague work it's way under!! When you've done all the track repairs make sure the board hasn't gone conductive around the battery area. I've seen so many boards that look clean but still show voltages leaking across the bare PCB with the slightest bit of humidity. IPA doesn't shift it and I had to use a special aircraft cleaner solvent. Re-routing the 53v is also a good idea so I usually isolate the track at the PSU connector and roughly the middle of the board (where it's clean) and run a patch wire.

Here's a couple more pictures Graham as promised 🤣

https://www.rte.ie/archives/2017/0330/863803-coin-operated-gaming-machines/

Sold! 😂😂

I'll pay 30% more than Graham

Cheers Bob, great advise there. I've treated it much like a scorp1 with cleaning it up for contamination accoss the surface. The 53v and 12v rails i wanted to physically remake on them board so I've gone down that route... I don't want talk it up too much because I've not yet done a project board yet 😅 Right now I'm thinking about how I will fault find the Z80 gear if needed, ive never touched one before and I don't have a comparison board. Could take months to get it running still. I'm up for it though its where the challenge is

Hi J I've been using this….. Silverline 60/40 100g Reel 1mm Fluxed Solder Wire. Was £4.98 inc postage when I last purchased (off eBay) a year ago. Seems to work well….

When the time comes Graham, you will be top of the list! It is quite good gameplay, many different ways to gamble. Nice machine really 👌

Well 2 year's later I have had time to take a look at this one again! Life is so busy. So after Ron had tested out the Sentinel mech for me, that was also 2 years ago, and it was all good. Started checking connections etc, and found that a couple of pins in one of the plugs to the coin and payout sides were slightly splayed out, and not connecting in the plugs correctly 😳 took bloody ages to find. Now she is accepting and paying out properly, so onto the next one!

'kin right I'm a top bloke Here y'are, Baking Bad roms..... Baking Bad roms.zip