Leaderboard
-
[[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]]
[[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]]
-
[[Template core/front/popular/memberRow is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]]
Popular Content
Showing content with the highest reputation on 07/21/23 in all areas
-
Switching the pin from 29 to 31 on Plug 2 is dead easy ..i just pulled the rubber sleeving back on pin 29 and held my hot iron on the pin for a second and it was released..then i applied a bit of solder to pin 31 and re-tinned the loose wire and dobbed it back onto pin 31 job done 😉 Says that on the post linked2 points
-
MPU2 machines need an extra rom in order to work. It's included in this starter layout, if you want to finish it off. The extra rom should work on all MPU2 machines in MFME. Most of the settings in the layout came form the other MPU2 machines already done and might not be 100% accurate. Just fix if needed. Fruitopoly.zip1 point
-
1 point
-
If I remember rightly, Stef had the same issue on a double up, there is a topic on here somewhere about it, and it’s to do with moving a wire 👍1 point
-
Just in case it helps here are some docs, one shows the sru layout and someone has penned in what each chip/area does might be usefull, also large scale schematic JPM_Eachway_Nudger_Operating_Manual.pdf1 point
