Leaderboard

yeah, Barcrest logo below slots on earlier games (IR, EU, A&L) and then they decided to lower slots on LU and relocate logo above (don't know why, except maybe to make slots more accessible to younger players when converted) first pic of SLU is confusing as a frankenfruit (looks like LU built into EU cab) factory LU's had Cancel button spaced slightly away from Nudge Ups (on EU, all upper buttons spaced equally and in relation to 20p slot) LU's reels are closer to RHS of cabinet (by half inch) than earlier games so buttons followed (usually 8mm gap between RH edge of Start button base and RH frame edge on LU, 14mm gap on EU & A&L - enough to run finger between - if you run a straight edge down from groove in centre of upper frame divider, left of 10p slot, should, on factory LU cab, more or less line up with LH edge of reel-3 Nudge Up orange insert, give or take a mm or two, as slight tolerance for top glass and coin plate in upper frame).

@EddieC, this is so satisfying to see. You are doing an amazing job, thanks for sharing

Finishing Lamp Mask Next step is to bond the 3D printed parts together. The filament I used was PETG. I sanded the mating surfaces and then applied PET Gloop! glue on each surface. Then clamped the surfaces together to keep alignment. After an hour for the glue to set, I drilled the 17mm holes for the top and bottom for the feature lamps.